Martin RoboColor III Uživatelská příručka stáhnout pdf (Strana 12)

Creating sequences and shows

Using the

sequence

editor you may create

sequences

that match the physical dimensions

of the room you are lighting. Later, by using the show editor you may link the

sequences

make

shows

which can last for hours without the need of an operator. You can edit your

sequences

and

shows

at any time.

Edit sequence

1 Press [edit seq]. The status of the display now changes to {01 }, where 01 indicates

sequence number 01.

2 Press [↑]or[↓], or, use the joystick to change the

sequence number

. Confirm by

pressing [enter]. One of two things will happen:

3a If you are about to program a new

sequence

you will be placed in step one ready to

program

scene

one. The display shows {

sequence number

} and {01}

scene

one in the

sequence

,or

3b if the

sequence

already exists the display shows {Pr }. Press [enter] and the

sequence

is ready to be edited. You are now ready to edit the first

scene

Depending on which Units are configured to which channels, (1) - (8) turn on. This is

done automatically by the controller, which scans all the channels and turns on the

LEDs of the channels which are configured to Units of the same type as the Unit on

channel 1.

4 Select the Unit(s) to be programmed by pressing [1] - [8]. (1) to (8) will be lit

accordingly. If a Unit different from the one currently in use is selected, the LED for that

channel is turned on and all others turned off. Use the function keys described in the

Appendices B to F to program the Unit now in use.

5 When you are satisfied press [enter] to go to the next

scene

. The right part of the

display will show the new

scene

number. Note that the last

scene

in a new

sequence

is automatically saved by the controller and you should not press [enter] in order to

store this. Press [enter] only if you want to add another

scene

to the

sequence

6 You may browse through the

scenes

by pressing [↑]or[↓] to make some changes in

the positions or effects if necessary. If any changes to a

scene

are made - press

[enter] to save it temporarily.

7 When you are satisfied with the whole

sequence

, save it permanently in memory by

pressing [edit seq]. The display will show {SAXX}, where XX is the sequence number,

until the

sequence

is saved. If you still have

scenes

to program, continue as described

and save again. It’s not possible to increase or decrease the number of

scenes

in a

sequence

after you have left edit-sequence mode. The limit of

scenes

in any

sequence

is 99. If you press [enter] in

scene

99 will be placed in

scene

01.

NOTE Do not turn off the controller whilst saving or deleting

sequences

as the

information in a

sequence

could be lost - not fatal but annoying as the ruined

scene

in the

sequence

has to be found, edited and saved again.

Martin 2308 Controller Version 2.1/3.1 Page 13

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 60 61

Komentáře k této Příručce

Žádné komentáře

Martin RoboColor III Uživatelská příručka Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Světlomety Martin RoboColor III