Martin MiniMAC Maestro Uživatelský manuál Strana 34

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 51
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 33
34
Stand-alone operation
Prev (previous scene) scrolls backwards through scenes on
selected fixtures. The fixture blinks three times when the
first scene is reached.
Next (next scene) scrolls forwards through scenes on
selected fixtures. The fixture blinks three times when the
last scene is reached.
Store (store scene) saves effect and timing settings to the
current scene. Fixtures confirm the command by blinking
twice.
Delete (delete scene) removes the current scene from
memory. Scenes above the deleted scene are renumbered.
Fixtures confirm the command by blinking twice.
INS (insert scene) creates and saves a new scene before the
current scene, which moves up a number. Fixtures confirm
the command by blinking twice. If a fixture blinks three
times, its memory is full.
ADD (add scene) creates a new scene at the end of the
sequence with the settings that are active when the scene is
created. Fixtures confirm the command by blinking twice. If
a fixture responds by blinking three times, its memory is full.
EFFECTS ADJUSTMENT
The look of a scene is programmed by first selecting an option with the effect
selection buttons and then adjusting the option with the position adjustment buttons.
When two effects - pan and tilt for example - are assigned to a selection button, the
up/down arrows control one effect and the left/right arrows control the other effect.
If there is only one effect, the up/down arrows usually provide course adjustment
and the left/right arrows usually provide fine adjustment. The middle button returns
effects to a default position.
Some effects do not apply. The fixture acknowledges valid effect selections by
blinking once.
EXECUTION
The Run/Stop button toggles scene execution on/off on selected fixtures. Scenes
execute in a continuous ascending loop.
All remote control functions except Run/Stop are disabled during execution.
The Store Remote Status personality option, which is active by default (see
“Control panel” on page 14), links the Run/Stop action on the IR remote to the
execution settings for stand-alone operation. This means that when you select run or
stop via the remote control this will update the fixture’s execution settings. This
enables you to – via the IR remote - switch on or off the automatic starting of stand-
alone operation when the fixture is powered on.
00 01 02
00 01 02 03
00 01 02 03
Store saves
settings in the
current scene.
Add saves settings
in a new scene at
the end of the
sequence.
Insert saves
settings in a new
scene before the
current scene.
Zobrazit stránku 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 50 51

Komentáře k této Příručce

Žádné komentáře